麻豆官网首页入口

Key points

  • Water waves are ripples that travel through water.
  • Water waves are and can be from surfaces.
  • When two waves meet, they either add together or cancel each other out. This change of two waves into one wave is called superposition.
Back to top

Water waves

If you throw a pebble into a pond, ripples spread out from where it went in. These ripples are waves travelling through the water. Like ocean waves, these ripples are transverse waves because the surface of the water moves up and down, at 90掳 to the direction that the wave is travelling.

An image of some water waves, the top bit is labelled as 'peak', the lowest point is labelled as 'trough', there is a dotted horizontal middle line between the highest and lowest points of the wave labelled 'rest position'. There is an arrow from the rest position to the top of a wave labelled as 'amplitude' and a horizontal line from one peak to the next peak labelled 'wavelength'. There is an arrow pointing from left to right labelled 'direction of wave'
Figure caption,
A transverse wave travelling through water

If you stand still in the sea, the water rises and falls as the waves move pass. These waves have , , a , an and a 鈥 just like a transverse wave travelling along a rope.

An illustration of a hand holding a rope with two large peaks to demonstrate a transverse wave travelling along a rope
Image caption,
A transverse wave travelling along a rope
Back to top

Reflection of water waves

Water waves can reflect or 鈥榖ounce off鈥 a surface.

For example, ocean waves are reflected when they hit a harbour wall, just like light waves reflect when they hit a mirror and waves in washing-up water are reflected off the sides of the sink.

Water ripples in a bucket
Image caption,
These water waves reflect when they hit the edge of the container, causing the liquid to slosh around

Reflections can be shown using water in a baking tray. The experiment below allows these reflections to be seen and can be carried out at home.

Image gallerySkip image gallerySlide 1 of 4, An image of a tray filled with a shallow layer of water in., 1. Fill a deep baking tray or similar container with water, to a depth of 1-2cm.

The speed of the wave can be calculated by measuring the time taken for the wave to travel across the tray and using the formula:

听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听听speed = distance 梅 time

Allow the wave to reflect several times and measure the total distance travelled and time taken, to get an average and therefore obtain a more accurate result.

Back to top

Superposition of waves

Adding

In phase means that the peaks and troughs of the first wave line up with the peaks and troughs of the second wave. If two waves meet each other in phase they add together.

This produces a wave with a greater amplitude, so the peaks of the resulting wave are higher and the troughs are lower.

An image of two wavy lines being added together an creating a new wavy line that is bigger (goes higher and lower)

Cancelling

If two waves meet each other out of phase, when the peaks of the first wave line up with the troughs of the second wave and vice versa, they cancel out.

If two waves meet each other out of phase, when the peaks of the first wave line up with the troughs of the second wave and vice versa, they cancel out.

This means that the amplitudes of the two waves subtract and create a smaller wave with an amplitude of the difference between the two. If the two waves are of equal amplitude, then they will cancel out completely.

Two waves with opposite peaks and troughs adding together and creating a flat line (no wave)
Back to top

Test your knowledge

Back to top

Play the Atomic Labs game! game

Try out practical experiments in this KS3 science game.

Play the Atomic Labs game!
Back to top

More on Waves

Find out more by working through a topic